MultiWii

izeman wrote:.) i had to set "serial protocol" from "none" to "hub" at my remote

What is your remote, bro? I don't see it at my taranis settings.

but in your situation you need one that works both ways Are you sure? I don't see any information where receiver asks sensors using Tx/Rx pins. May be you are talking about X 8R with Smart Port connector? I have D 8R-XP. I've read already here about bi-directional converter for X8R and s.port. Can ...

it does not convert the logic voltage level It would be strange if this inverter did not convert the voltage level (Vcc <=> Gnd). Otherwise it wouldn't happen to work... Thus, it is most problably not only a cable, but a cable with integrated converter in the middle. BTW hobbyking cable inside. I w...

BTW, i had different result. With pin12 and with com3. On the taranis o saw different values on some ID's

It is just only for testing telemetry. I don't want to fly on it As i understand you want to try any version just for test if telemetry works or not, am i right? I tried MultiWii2_3-navi-b7-frsky.zip version. It was not operational at all for me. Try MultiWii_HEXA2.zip I will reattach zip file where...

Do you have this board? I have the same if yes. Have you tried the file multiwii-firmware-telemetry_2.2.zip from this topic? Size is 149649 bytes Try to change Serial 3 to pin 12 in the file config.h Use strings: #define TELEMETRY_FRSKY_SOFTSERIAL_PIN 12 #define TELEMETRY_FRSKY_SERIAL 9600 Don't for...

Have you connected the battery, izeman? Have you done Clean EEPROM? I did it before every firmware uploading. I mean yesterday i did some tests just using USB connection and everything was working fine except the multiwii telemetry. I have zeros in all ID's and was in a shock, but then just connect ...