MultiWii

Hi, The values that worked for me were 10uF and 1K ohms, though capacitor values as low as 1uF should work but you'll need to increase the resistance value to 10K ohms. Be aware that longer RC time constants would likely result in sluggish readings. As an aside, I've since added a MinimOSD w/ KV Tea...

Ancient artifact. Got it. Thanks!

Enable in-flight level calibration is an option under Baseflight's Configuration tab and CALIB (which I'm assuming places the model into in-flight calibration mode ) is an option under the Mode Selection tab. Anyone ever use these features because I can't find any reference to them anywhere. I'm cu...

RESOLVED. In the Baseflight GUI under the 'Configuration' tab is an option for " Enable GPS (PPM or 3rd serial port required) " The keyword here is "or" which needs to be changed to " and ". I had PPM enabled but that was not sufficient. Once I enabled the 3rd serial p...

Not a stupid question. Always with battery.

; )

I just received my House uBlox 6M GPS Module V2 from RTF Quads and I cannot get any data from the module when connected to my Rev 5 Naze32 board. The module has power, and I've doubled-checked the Tx/Rx connections as per the example photos. In Baseflight I have GPS enabled, GPS type set to 1 ( Ublo...

I received a response from 'geebles' on the RC Groups forum that solved the mystery. As I suspected the Naze32 cannot read the FrSky PWM RSSI data however, there is a workaround in that you can configure a pin on the Naze32 to accept an analog RSSI voltage via the CLI using set rssi_adc_channel = 1 ...

OK. Turns out the FC was partially bricked. No USB. No Bluetooth. No nothing. Fortunately it was under warranty and the retailer sent a replacement. I even purchased a second unit for another project (and as a backup =).

I'm setting up a Naze32 for the first time and have run into a snag; I'm not getting an RSSI reading from the Rx. Gear: Full Naze32 - latest firmware Baseflight - Windows 7 Ultimate FrSky Delta 8 in CPPM mode Naze32 set to read RSSI on AUX 3 FrSky RSSI output connected to AUX3 AUX 4 is connected to ...

In that long post I missed what it is that you actually did and what is it youre trying to do. What is the "third serial port" checkbox? After updating to the latest firmware I also can no longer connect via USB. The board isn't 'bricked' (it boots and it flies) but it is now utterly usel...

Naze32 full. About a week old. 2 Flights. Latest drivers. Latest firmware. Latest Baseflight. Windows Ultimate 64. Everything in Device Manager looks normal with no errors reported. Tried several different USB ports. Tried several different USB cables. Still cannot connect to Naze32 board. The last ...