MultiWii

I'm familiar with that page, and have used it to come up with mix parameters for my spider-quad. I'm trying to figure out what the correct yaw parameters should be. The linked page says to set them to be equivalent to the roll value, which will cause the quad to roll about its center. I don't unders...

I have two questions about motor mix parameters. 1. Does the absolute value of motor mix parameters matter, or only their relative value? If I have a quad with motor[0]=PIDMIX(-1, 1,-1); // Back Right Is this the same as: motor[0]=PIDMIX(-2, 2,-2); // Back Right 2. If I were to increase or decrease ...

Sorry--are you suggesting that the FC should not be vibration isolated from the frame, or that it should be?

I am setting up my first quad, and using MWC. I'm having some trouble getting the alignment of the FC exactly right. It would be ideal if this problem could be solved in software, and I think it probably can. I have found references to forcing sensor orientation, which I think is what I'm looking fo...

Jackpot. Downloading the most recent version of the MW GUI and then reading/writing the config back to the board fixed it.

Possible jackpot.

viewtopic.php?f=18&t=4352

I have messed up my config somehow and need some help. I completed my build and got some brief flights in late last night in acro mode, so I know the copter was working fine. I went back in the house and did some additional configuration, including tweaking the channel limits so the PPM was correct ...