MultiWii

i didn't get this PID tuning theory. According to it i have Increased P term untill the quad start to oscillate and ruduced a bit. But what about the I and D terms how to set them for stability? i want to tune the quad for stable mode. With the current PID setting my quadrotor takes off and then sta...

how you have mounted the controller board on the center plates. Because in my case when i mounted the controller board with metal nut bolt it used to transfer lot of vibrations to the sensor. Then i replaced metal nut bolts with the NYLON nut bolts and all the vibrations are like gone. So if you are...

Hello Guys, I Have Completed My QuadX Built with ProMini+WMP+Nunchuk and Tuning it for Maiden. One thought Came to my mind is about the landing gear for My QuadX. Main thing for any Beginner is to protect his Quad from hard landing and Therefore i thought about implementing the spring suspension on ...

ok thanks patrike i will do it now and will let you know the updates

i tried to do that but it does not help out. today i connected the board with GUI and gave the throttle but it seems in the GUI itself that the throttle given to the front right motor is higher than the other and the throttle to the rear left motor is lower than the other and remaining two motor run...

have you solved the problem because i am getting the same thing even after calibration of the gyro and acc. my front right motor runs faster than the other and the left rear motor runs slower as compared to other taking the quad to back and left on roll axis. i am using the setup of WiiMotion+ with ...