MultiWii

timecop wrote:Why would anyonee set failsafe_delay to 0? That means it would failsafe on every cycle, which is dumb.
Again, its also dumb that GUI/cli allows setting it to zero, but... whatever I guess.

Here's the post where it was suggested.
http://www.rcgroups.com/forums/showpost ... count=1965

Did u click save? I did. The problem ended up being the failsafe_delay set to 0. I have a receiver fs but read in a thread to set the failsafe on the naze32 as well in case the receiver gets disconnected. They suggested O and default was 10. I set it to 1 and everything works again. Not sure why th...

Full naze32 and taranis radio. I have my modes setup on a three position switch. When I change the switch position I see it change in baseflight config but the board led's don't change. Any help would be appreciated.

What 'other fucking pins'? There has been no pinout changes between any revision since r0 of years ago. If you're running latest firmware on both boards then the issue is elsewhere. I'd check for bridges on 2 8pin components near the RC inputs - but then again, neither of those are close to RC3/4, ...

Tr3TopFlyer wrote:What supported features would require GPS? is there a RTH or position hold?

Yes

I have a naze32 rev 5 with my battery voltage connected to the battery pins and the frsky telemetry pins going to the rx and grnd pins on my d4r-II receiver. I also have a house ublox gps connected. I'm getting gps info on my taranis telemetry screen but not the battery voltage. Is this setup not c...

I have a naze32 rev 5 with my battery voltage connected to the battery pins and the frsky telemetry pins going to the rx and grnd pins on my d4r-II receiver. I also have a house ublox gps connected. I'm getting gps info on my taranis telemetry screen but not the battery voltage. Is this setup not ca...