MultiWii

This PDF filter is working very well for at 20hz. special thank to you ziss_dm. Is it doable and efficient to have this filter between 10 and 20? #if defined(ITG3200_LPF_256HZ) || defined(ITG3200_LPF_188HZ) || defined(ITG3200_LPF_98HZ) || defined(ITG3200_LPF_42HZ) || defined(ITG3200_LPF_20HZ) || def...

By trim I just mean the normal TX trim on the axes that is being effected. The ACC trim, how much effect does each click have? I tired doing 4-5 trims in the manner you suggested with little success before I posted here. Does it need allot more, say 10-20 to make a reasonable impact?? Iv'e looked b...

it starts to drift (normally backwards) then i trim fwd a little and a few more seconds latter its drifting backwards again. This can go on until I have my trim maxed out i didn't know that one can TX-trim its Acc while in the air but gyros. try to trim your Acc on the ground with the max trotthle ...

me too i'm facing a serious problem with Fail safe. i've kinda 3 fails safe : within the multiwii code, within the quadrino FC and within the Rx/Tx. i've made a test by shutting off my Tx and...absolutely nothing happened ;(props remain turning at the same speed until i switch back on the Tx. don't ...

thanks Alexinparis, very good job !

i'm using the dead band and on the GUI, digits are still slightly moving up or down. is my hitec optic 6 causing this?