MultiWii

Sure. The idea is to display an Ad with two drones during the conference. What i mean with this can be understood if you watch my first test-run here m (in addition to the physical ad i want to distribute a digital one by a BT-beacon. This will be done by adding a RAspberryPI on top of the drone, th...

omg - the baudrate was the right hint, thanks so much PatrikE! Don't know why i changed this at all, must have been accidential. What a relief...

The Board does have a Mini-USB connector - i am using this.

Thanks, but this does not seem to solve the problem. I connect and the serial led is flashing as if data would be transferred. But nothing is displayed in the app...

Hi all, i am running 2.3.2 on MultiwiiMega (m), Multiwii Config on a Mac. Everything went fine so far but suddenly the Config Program does not read any values anymore. I can connect, it get's green but when i press "Read/Start" i only see a flat line and also no values in the PID settings....

Hi all, this is a very unusual request i guess... I am the CEO of nugg.ad, a Berlin based Tech-Company. We are running a conference on data-driven business models and ideas called Data-Days on October 1st and 2nd in Berlin. As a side program we planned to perform a special "show-act" with ...

ok, lesson learned - rtfm... Yesterday my new GPS receiver arrived. Because i thought that the em406a does not exactly meet the specifications of Multiwii as it only has 1hz Updates and a maximum baudrate of 38400 i ordered another one that has 5hz Updates and can communicate at 57600 baud-rate (m)....

Hi all, i am using the Mega-Board as FC (m) and attached an EM 406a as GPS-unit. I can read the GPS data through the serial monitor (on the mac), unfortunately the EM 406 only supports baud-rates up to 38400. I activated everything in the code, correct serial port, baudrate (19200), nmea as protocol...

Unfortunately yes - Values are below 1050 in low position. I also played around with trimming the transmitter which helped a little but did not seem to resolve the problem. When i start the copter for instance one side is lifting up and he will turn upside down - shouldn't the other motors immediate...

Hi guys, i am really stuck and need your support... I am using Flyduino Micro as FC and MW 2.32. I did get the copter in the air for a few seconds (see video here m), but the problem is that i cannot get it stable by any means, although i played around with PID options a lot. Everything is calibrate...

Hi all, i am trying to get my Quadcopter running with an Arduino Yun. I cannot get it to work with the Spektrum AR8000 Receiver properly, the signals are not getting through (bars in config-app are not moving when i move sticks). I tested the exact same config with an Uno and bars were moving. Then ...

Hi all, i run multiwii on an Arduino Yun. My problem is that my RC does not seem to work, e.g. i cannot arm and in the config app i see no changes when i change the stick positions etc. I checked (with a different test-sketch) whether the rc signals are reaching the board which seems to be the case....