MultiWii

HFMan wrote:In the standard configuration, the OSD is using the same port that the USB is. You're going to have to remove power from the OSD.

thanks mate!!

Hi guys
I'm trying to calibrate my escs but when I connect the main battery the software locks... I'm using a Kv osd connected to the naze tx rx. My friend says that I need to disconnect the osd, but every thing is soldered... there is any way to do this? you guys also have this problem?

regards

It was the vibrations that were causing it. I got the vibration dampeners this week, so I padded the naze with them and went out end flew really agressivly. Like 4 batteries of only hard turns, flips and rolls. No more drift. Before I got drift after every single flip. So problem solved So the conc...

Thank you so much timecop!! As always, fast and precise reply!! thank you!! Hi guys, just two quick ones. 1 - It is normal the cube that show the position of the quad on baseflight be turning on the yaw axis even the quad being standing? (I have notice if I still on hover it start to give just a lit...

Hi guys, just two quick ones. 1 - It is normal the cube that show the position of the quad on baseflight be turning on the yaw axis even the quad being standing? (I have notice if I still on hover it start to give just a little bit of yaw) 2- I add the command "deadband = 10" but my stick ...

Thank you!! I really appreciate your help a the swift replay!!
now time to go to the first flight!
best regards

Hi Timecop! Thank you!
yes enable
I do not know if can have something related to this but I use mode 1 on my RC

Hi guys just bought naz32 acro pink... and i have made all settings but when I put the roll stick to the right i got it arm and full left disarm... also works with the yaw like the manual...
what could be wrong?
do you guys have any tips?
regards