MultiWii

Hi I am struggling with the exact same problem .........just can't get a beep out of the buzzer .........I have assigned v-bat to A14 ...... Now The power meter is working on GUI .............. did you ever get resolution ??

Arakon, Thanks for the info that really helps .......... I have now got the serial RX orange uhf open LRS working ! on A8 Input of the multiwii.. next I am about to try the setup with the orange SAT RX ( two projects going off at once ) still tying to figure out why the buzzer (beeper) won't coopera...

Ok I have been trying to find out if it is feasible to use either a spectrum type sat Rx(just the sat) OR an open lrs orange rx ( ppm using RX ch5 configured for serial out ) with the hobbyking type fc (MCW MEGAv1.0 ) multiwii pro 2.0 My problem is not the software but knowing where to make a connec...

Ok I have been trying to find out if it is feasible to use either a spectrum type sat Rx(just the sat) OR an open lrs orange rx ( ppm using RX ch5 configured for serial out ) with the hobbyking type fc (MCW MEGAv1.0 ) multiwii pro 2.0 My problem is not the software but knowing where to make a connec...

just tried it out (in the dark) ...in my yard trees everywhere..baro + position hold worked well ...........copter drifted around in an area within a diameter of around 6m with light wind GOOD JOB !

Been using (hobbyking)multiwiii pro with mtk3329 gps (115200baud ) on gui2.1 now decided to try out 2.3 with nav. which sound like it should be fantastic for what I have seen on you tube Downloaded the two files from m everything looks good on the GUI However when I fly the quad "position hold&...

I have the mutiwii pro with the atmega 2560 ? I manager to down load the gui no problem. But i cant get the sketch ( from you message) to open up in to the arduino "box " cant drag the files across or get them to open up by clicking on the arduion Icon in the files list ( after unzippig .....

thank you i will take a look ..is this a new gui or sketch ? my computer is old and down loads are challenging so to know what I am looking for will help for sure

Thank you !!!!!!!!!!!!

where can I find the b4xmas downloads ? to enable using multiwii pro with missions sorry to ask on this thread this is the only mention of it I can find

Ok so I have a quad with mutliwii pro (from hobby king ) had it for a whlie .was working fine After watching a you tube vid ..I just upgraded to mutliwii gui 2.3 now having problems with "mission"on the rc control setting page (where you set up rth althold baro and MISSSION to the aux swit...