MultiWii

The maximum endpoint I can specify is 120% and that still doesnt do it.

Anyone have any suggestions on getting this range out of the FlySky 6ch TX? I have changed the endpoints etc. but cant get close to the 1000 or 2000 mark. I sit from about 1180 to 1800.

So I've completed everything and attempted my first liftoff. It was very anticlimactic as my quad stayed firmly planted on the ground. I have confirmed that my CR props are on my motors that are spinning CCW and my standard props are spinning CW however when I hold the quad and give it throttle it p...

I couldnt set the limits correctly using the tx software so I had to adjust the MIN MAX values in the code and I can now arm/disarm. Thank you all

According to the FAQ the LED goes off. "The motors do not start Move the rudder full right with throttle all the way down to start the motors, full left to turn off the motors. If the LED stays off, it is a problem related to the RX setup. If the LED is going ON after the arming procedure, it i...

I have everything connected and wired properly according to the Config GUI. All channels are recognized from the TX, sensors act properly however the LED on my arduino turns off after I attempt to arm the motors. I believe this is due to my throttle settings however I cannot get close to 2K max with...

Is there a reason not to use the leads that are already on the WMP except for making the board more compact? From everything I have seen everyone is soldering to the underside of the pins that already have wires coming from the white harness. Is something crossed in the harness making this a bad idea?