MultiWii

Hi all Have same board from rctimer(Mwii v 2.5 standard) and even tough I seem to get the "OK" at the end of eeprom clearing and mwii 2.3 uploading, I cannot connect to my board in the MWII GUI...I have a crius AIOPv2 using same version of mwii and same gui and it works fine(usb connection...

Yeap...cleared eeprom before fresh mwii 2.3..
I also hoped it will cure it but only caused a small crash on grass:(

Same cutoffs and glitches on the same motor which worked well connected directly to receiver+esc...so maybe my crius is gone?

Just recalibrated esc throttle range and swapped motors... Guess what; when I try directly from the receiver the motor starts nicely, when i hook it to my crius aiop v2 it starts almost at 50% throttle...

Ok, but then why would this symptom affect only one motor?

I have hobbywing 30a esc's, just normal ones...I changed the rear right esc and I still have the issue

Hi scrat...
They are both v 2.3 and my quad flew well untill this happened...
Tx for the idea anyway

Anyone ?

Hi All Have a flip fpv using crius aiop v2 with sunnysky x2212 kv980 motors on 3s. I have mwii 2.3 which flew great untill few weeks ago, when without warning the rear right motor shut off during hover and I crashed...This motor spools up latest and I set up throttle range correctly for all motors. ...

Now my rear right motor spools last and sometimes shuts off in flight for few seconds...No idea why...

Hi Brian, Surprised to see your answer here I figured it out...basically I need a new firmware otherwise the osd will not be recognized by the multiwii... By the way, I love the way Mwii flies...been testing it last week-end...glad I left MPNG and joined the mwii community. thanks for that tip. Enjo...

I have it connected, worked before on MPNG but since I switched to MWII 2.3 all I got is awaiting heartbeats message... So I guess I must enable or define it, but not really sure how ...
Any help is appreciated.
Thanks

Hi Guys,
I'm new to Multiwii...I have a minim osd compatible board from GLB website that worked well under MPNG 2.8 which I used before on my Crius AIOP V2.
What mods I need to make to my config_h to enable the osd board ?
Any hints are appreciated
Thanks

I setup minthr at 1045 and all work fine now. It is very important for mwii to have this set up right...Also since I changed this the motors arm/disarm flawlessly everytime.
Hope someone with similar issue will find their answer here...
Thank you both

Hello All,
I dont want to double post but I appreciate if any of you can help with this issue I have here
http://www.multiwii.com/forum/viewtopic.php?f=18&t=4454&p=44860#p44860

Hello All, The issue I have is that since I used MPNG 2.8 with tough times adjusting PIDS, I decided to try MWII also and since I heard only good things about the ACRO mode and the commodity of BT connection I thought I give it a try... Problem was that I have strange motor readings in the GUI. I am...