MultiWii

High folks, the solution for the WM+ clone with IDG650 and ISZ650 IC's. I found the solution in a german forum. m The laurels are going to "QUAX". He found that the I2C-STOP-condition for the clone is tooooooooo short. If you have the same WM+ clone and the clone will not work with "M...

Hello folks, 1. The clone WM+ with the IC's IDG650/ISZ650 is working on a Wii. 2. Not working with the MultiWiiV1_7 Setup: Clone WM+ only; MINIPRO328 board I did some scope measurement on the clone WM+ (IDG650/ISZ650). Refer to the NXP spec "UM10204" I receive a "Not Acknoweledge"...

Thanks folks, problem is solved. I received yesterday two new WM+'s. Original NINTENDO Wii Motion Plus devices. 8.90Euro per piece inclusive TAX, custom and delivery. The PCB is equipt with an IC ITG3205 and they work. The two others with the IC's IDG650 and ISZ650 doesn't work at all. I will check ...

Hello folks, I need help!! I use a WMP with a IDG650 / IZG650 IC's , the Arduino is a MINIPRO328 and the software is V1_7. I use a original Wii connetor, soldered to the Arduino board. Nothing works. Removing the WMP and install a Nunchuk to the Connector, changing to Nunchuk alone in the SW, I see ...