Search found 6 matches
- Sun Jun 22, 2014 8:27 pm
- Forum: ESCs, propellers , servos and radios
- Topic: Different motor rpm
- Replies: 16
- Views: 12713
Re: Different motor rpm
So I did get my quad in the air after all tough there was little oscillation! The problem was that I didnt calibrate sensors properly before flight and didnt give enough throttle in the takeoff. Now I just have to set PID-values correct and learn to fly the thing.
- Thu Jun 19, 2014 6:10 pm
- Forum: ESCs, propellers , servos and radios
- Topic: Different motor rpm
- Replies: 16
- Views: 12713
Re: Different motor rpm
I tried to set the sticks to travel from 1005-1995 but I somehow didnt manage to change the pitch values so I propably have to let it be 1000-2000. :/ I checked that the motors were in their respective locations (ESC:s connected to right pins 9,10,5 and 6), spinning directions which were ok too and ...
- Wed Jun 18, 2014 9:18 pm
- Forum: ESCs, propellers , servos and radios
- Topic: Different motor rpm
- Replies: 16
- Views: 12713
Re: Different motor rpm
Ok, so it tried to fly the quad but with no success. When I gave minimum throttle the quad just flipped over. How much does the frame balancing effect on the takeoff? Anyway heres a printscreen from GUI, the front_L and front_R motors have 160 rpm aberration on the ground with full throttle and im q...
- Mon Jun 16, 2014 10:55 pm
- Forum: ESCs, propellers , servos and radios
- Topic: Different motor rpm
- Replies: 16
- Views: 12713
Different motor rpm
Hello! Im just about getting my first quad in the air but before im putting props on it I have a small ( or big ) problem to solve. When I arm the motors in the GUI the motors are idling somewhere about at 1050 rpm and when I start to give some throttle the motors rpm will vary 50-100 rpm. I have ca...
- Thu May 22, 2014 12:57 am
- Forum: Shields, boards and sensors
- Topic: Need help with mixed stick commands!
- Replies: 3
- Views: 1469
Re: Need help with mixed stick commands!
Just fixed the problem with just swapping the cables! Took some time to fix it but better later than never. ;D But anyway, thanks a lot for your help! (:
- Tue Dec 24, 2013 4:34 pm
- Forum: Shields, boards and sensors
- Topic: Need help with mixed stick commands!
- Replies: 3
- Views: 1469
Need help with mixed stick commands!
Hello! I bought MicroWii ATmega32U4 fc and flashed it with multiwii 2.3 software. The problem is when I hook up the fc to GUI it shows me that pitch and roll have changed places on the stick and roll is on aux1 channel. Though yaw and throttle are ok. I triplechecked the receiver connections and the...