Search found 7 matches
- Mon Dec 23, 2013 3:19 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
OK when I get back in front of the setup I'll have a look. I did see the gimbal section under the servo tab but I could not get the servo to move on any channel. My Futaba 8fg AUX8 is controlling AUX4 on the MWC. Again I'm new to this so bare with me.
- Mon Dec 23, 2013 1:54 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
OK got that servo plugged into S1 and my ECS's plugged two slots lower. I've changed the mode to servo and they motors arm and throttle up just fine. Now the servo in S1 I'm not sure what channel it is on. It does not show up on MWC. If I am understanding correctly I now need to map EATR4123 to be a...
- Sat Dec 21, 2013 12:01 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
I did. The reason why I ask such trivial questions is b/c the manual says if you put things in wrong you can destroy the board. This is my second servo the first one burned out luckily the board still works.
I'll shift my ecs's down and try plugging the servo into the S1-2 slots and see what happens.
I'll shift my ecs's down and try plugging the servo into the S1-2 slots and see what happens.
- Sat Dec 21, 2013 3:26 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
ok another question. I'm using PPM and I have all my ESC's connected to the Naze they are arm and spin up just fine. I now want to connect a hitec HS-65MG servo for a gimbal to move a gopro up and down. Where on the Naze do I plug this servo into? I'm using a futaba 8fg and have the LD knob controll...
- Fri Dec 20, 2013 1:16 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
OK i've figured it out. I don't need the Naze in the picture. I can connect the IRC VTX right to the same 4s powering the Naze. Problem solved.
- Thu Dec 19, 2013 11:19 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
Im actually running 4s.
- Thu Dec 19, 2013 9:19 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1413921
Re: Naze32 hardware discussion thread
I'm new to the Naze32 boards. I just got my pink regular one not the acro. I've been reading and found a lot of info on these boards. How do I connect my ImmersionRC 5.8GHz VTX to the Naze32 to draw power. I am running with a 5V cam that will be powered off of the VTX. It's getting the power to the ...