MultiWii

Neat trick. I have to give that a try. I'm also having problem flashing my board. I got a buddy to flash for me and seems to work with his set up on baseflight. I hooked it up on clean flight and got the welcome screen and able to edit PID but that's all.... No telemetry osd overlay. I thought I con...

I think I killed another naze. No led at all when connecting with USB or flight batt. I am using a 5v bec. The output of 5v goes to naze and rx, mwosd all got power from pins from Naze board. This was the SS 5v/3a ubec I used before.

Can batt pin (for telemetry read back) take 4S batt or do I need a divider?

Thansks for your input. I just checked my telemetry data from my last crash but it didn;t show any smoking gun. I was flying with RMRC 3300maH 35C. My other theory was may be the high C battery allowed for more current. Too much such that the ESC was over worked and was not able to sustain the 5V ou...

I'm about out of idea so any input is greatly appreciated. I have a Naze32 ACRO in BO mini HEX with Sunnysky 2204 2300KV BS 12A simonk 9-30-12. I’m using Frsky DR4II in PPM mode without failsafe. I’ve already tested that if I turn off radio, all motors stayed the same position and came back right aw...

Yes. Looks like I’m one of those fuckers who manages to fuck up the Naze. It got fried the night I added the HK EOSD to the hex. My FPV gear runs of the filter output. I simply solder additional connector onto the LC filter to accommodate the OSD. After I’m done with OSD installation, I plug flight ...

Fried in a month. That's disappointing. I hope that this is an isolated case and my new one doesn't get fried in a month as well. I put my new acro naze into the same hex. Is there anything I should check to make sure it's not my set up that caused it to fry?

I've been flying my NAZE32 rev5 for a month and it's been working fine for me. Yesterday, it just stopped working. When I try to turn it on (USB to computer or flight pack), only the blue LED turns on and it did not go through the unual LED/buzzer sequence. I measured and verified that 3.3v on the b...