MultiWii

Is not there any other settings in the program? What is meant by MSP

excuse me, does anyone know where I can change the section PWM in program coding multiwii, I intend to change the value of the PWM but I have trouble finding where and where do the coding. Please help me

excuse me
I want to ask if anyone here knows about the flowchart of programming multiwii , I want to know flowchart of programming multiwii.mohon its support of the programmers or users multiwii

I use MULTIWII CRIUS SE V2.5 and I do not use GPS. the GUI settings allow me to make the value in the P POS, POS R, NAVR, LEVEL and MAG with a value of 0? whether there are effects or impacts that occur when I gave a value of 0?

excuse me, there were a little want me to ask. I use multiwii Crius se when I did a test on my GUI find on display, that I am not the same motor rotation. when thortle the low position four motor rotates at first but when I Rev throtle there is a difference in the motor.saat throtle located at 1500 ...

I've been filling in multiwii PID value using the computer and when I connect with bluetooth and ez gui I can not read that I have input earlier. and when I turn on the quadcopter, the graphics on gui ez also do not appear.

I want to perform tuning PID on multiwii CRIUS 2.5 SE belongs to me using the BLUETOOTH HC - 05 . however I have several problems , among others : 1. whether the arduino program there should I change or replace to activate bluetooth ? 2. I've tried to connect Bluettoth on multiwii with ez - gui appl...

excuse me I want to develop quadcopter with multiwii, but I have a constraint on PID. I have some questions: 1. how to translate the PID program on Multiwii? means the PID formula on multiwii was like what? 2. on the codding where I can find the settings for sensor calibration 3. there anything you ...

excuse me I want to develop quadcopter with multiwii, but I have a constraint on PID. I have some questions: 1. how to translate the PID program on Multiwii? means the PID formula on multiwii was like what? 2. on the codding where I can find the settings for sensor calibration 3. there anything you ...

all excuse me , I want to build quadcopter with multiwii . it's just that I want to modify the program, I wanted to include the value of PID permanently on the program. PID values ​​are not looking for a trial error in the GUI. if I can realize my ideas are ? Can you all help me , on the part of the...

I am having a problem with one brushless motor rotation, and rotation response that occurs is not the same with the other three motors. on the program or TX should I change to equalize the troubled motor rotation? some people say by changing the voltage or power on the ESC can change the value of th...

Thank you for the information, I will try It

if there is the influence of changing the tilt angle? to number 500 above it mean anything?

excuse me
I 'm making a quadcopter for my final project , I want to change the angle of the PITCH from 45 degrees to 5 degrees . on which part should I change ? whether the multiwii or on my TX ?

i used multiwii microwii 32u4 se. in datasheet this multiwii used arduino leonardo but when i upload file show this message.

hallo everybody
i want to upload file from arduino software but in processing upload show this message error. you can see the picture

please tell me about error in process upload

Hello everybody,
I'm newly buy Multiwii Microwii 32U4 SE, but I don't know how first setting this Microwii, can help me to setting this is.
thanks