Thanks Patrick
I will give these a try. So the first option is free, but the Eclipse I have to buy, right.
Sirod
Search found 5 matches
- Tue Sep 06, 2016 2:42 am
- Forum: General discussions
- Topic: MultiWii 32bit SW for VTOL - please advise
- Replies: 3
- Views: 10179
- Sun Sep 04, 2016 2:16 am
- Forum: General discussions
- Topic: MultiWii 32bit SW for VTOL - please advise
- Replies: 3
- Views: 10179
MultiWii 32bit SW for VTOL - please advise
I have been making simple modifications on MW2.3 for 8 bit controllers to get mixers for motors and servos for VTOLS (tricopter and bicopters based). There are also some codes for transitioning. My question are there already any arduino-like environment out there on the 32 bits baseflight or cleanfl...
- Tue Mar 01, 2016 2:32 am
- Forum: MultiWii tweaking - flying experience
- Topic: Altitude control without Baro
- Replies: 3
- Views: 5228
Altitude control without Baro
I am hoping someone have the answer for this. I have just converted a heli |(old TrexPro) to Flybarless using a NanoWii Board. I must say it is now stable enough for me to turn figure 8s. The NanoWii does not have a Barometer, the 'ALTI Hold' option is not enabled. I know some other firmwares utiliz...
- Tue Jan 14, 2014 2:29 am
- Forum: Software development
- Topic: Helicopter integration
- Replies: 318
- Views: 110474
Re: Helicopter integration
" Best verify servo signal freq with pwm meter - if servo is attached to motor output, then 490Hz motor signal sets servo on fire very quickly." Hamburger, I have the same servo connections per your suggested diagram But I noticed since changing to 2.3, the cyclic servos ran very hot, thei...
- Mon Nov 11, 2013 5:01 am
- Forum: Software development
- Topic: Helicopter integration
- Replies: 318
- Views: 110474
Re: Helicopter integration
Hello everyone I have been following this helicopter integration thread and I am pleased to report on a successful resurrection of my HBK2 from my junk box. Following are what I have used for the FBL conversion. - HK NanoWii as controller - 3 Turnigy 12.5gm digital, partially metal servos for the cy...