MultiWii

Hi, somethings wrong with GUI or with some config! Try to set Flaps on AUX 3, but if I klick "write" in GUI and read out the values, it jumps to "disabled". If I try to set servo-mid to "7" in mw-win-gui, it don't allow values lower then 1000. What can I do to set flaps...

Hi,

maybe I can take a video tomorrow, yesterday my KeyCam was empty on RTH...

Best Regards from Germany!
Chriss

Hi Patrik, I will give you a feedback with my Bixler2 and your RTH MultiWii Code! I don't change the defaults PID's and with that it works very well! Stabilize and RTH works very well! Thank you very much for that piece of Software! But I have a issue: if I connect the LiPo and the plane is not leve...

Hi Patrik, I have flashed new firmware to my Crius SE V2.5 in my Bixler2. Connect to GUI works fine, also the settings for switches and so on. I have only issues with servo settings. I cant save the settings (reversing) to my board. If I press "Read" (after "Save") its shows me t...

Hi there!

@Sirod: have you a Video in flight?

@Hamburger: yes I have a seperate collective servo. But I thought COLLECTIVE_RANGE setting have only an effect for the seperate collective servo. I will give it a try. Thank you for your reply.

Regards from Sauerland!
Chriss

Hi Hamburger,

here is my config.h:


I activated #define HELI_90_DEG
Have I something forgot for Heli with ProMini and MPU6050?

Thanks & Regards from Germany
Chriss

Hey there, I want to test MWii with Arduino Pro Mini and MPU6050. I downloaded the latest version. My Heli is a Walkera DF36, 90° swashplate and FB. Tailservo drive ok, and all sensors works well (in GUI), but nick & roll servo won't work. Both moved only a few degrees. Even if I switch to PassT...

Hi chriss, You're right. It's missed when implementing PID's for navigation. When using I2C gps only the PID's inside the I2C unit is used. At ~row 56 in gps.cpp. #if defined(GPS_SERIAL) || defined(GPS_FROM_OSD) || defined(TINY_GPS) Change to #if defined(GPS_SERIAL) || defined(GPS_FROM_OSD) || defi...

Hello, I am impressd of the good work! Thanks for that! I orderd Crius MWC SE v2.5 and want to install FC, GPS in my Bixler2 (Crius doesn't arrived yet). For testing I use a Arduino Pro Mini (only for testing compiling e.g.). When I want to compile it with I2C_GPS, there is an error in GPS.cpp (FW_n...