MultiWii

Hi, thanks for such a details reply. I have used the calibration sketch in the past but the motors were spinning correctly as they had been individually calibrated. Switch behaviour was setting Aux1 to GPS hold, Aux 2 to RTH, etc. all things I have done before. I haven't had time today to check the ...

Completed a set up with... Cruis AIO pro & multiwii 2.4 All props going in the right direction and ESC calibrated. System armed, motors spin immediately (no problems there). Test flight OK. Added some switch behaviour through the GUI (matched to the appropriate code), clicked on WRITE, all OK We...

Thank you. At least I can stop guessing. D

Hi all, I am trying to get my X8R to work with a MultiWii All in One Pro. I would like to make it 'talk' using a single wire. I'm having problems where the connect tons should be made and the Rx mode. Do I use Sbus, or SumPPM on pin 1? Hope this makes sense to someone. Thanks D

Hi QuadBow,
The Yellow GPS led acts differently to how you described it.
No fix flash
Fix of <5
Fix of >5 - 6= 1flash, 7=2flash etc

I had a feeling that a re-designation of a pin might work.

Thanks Dave

Good afternoon, I have a CRIUS MultiWii AIO Pro and I want to display the GPS status on another pin so that I can put a series of LEDs to show what fix I have. I have looked in many different places but have not found the answer I require. Any help would be appreciated as what little hair I have is ...

I have managed to pick up 5 v from else where om the board and it all works.

The Android mW config is only v2.1 so there are a couple of issues with switches.

Thanks for your help.

Dave

Sorry about that. The modules connected are Crius GPS v2 on serial port 2. Working ok. Bluetooth on Serial port 0 (Labelled FTDI / s0) The Bluetooth module is configured to 115200. There is no FTDI adaptor. The jumper for extended power is in place while using the esc power. I have tried an external...

My flight controller is a

Crius MultiWii All In one pro v2.

I hope this is what you want.

Thanks

Dave

Good afternoon, I have a CRIUS AIO board and a CRIUS GPS unit. It all works and flies. I have an Android phone and tablet and would like to use the app via Bluetooth. I have the module, however when I plug it onto the board (FDTI / S0), no light. Nothing! Checked the model on my PC and lights flash,...