Search found 5 matches
- Tue Jul 09, 2013 9:25 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1451367
Re: Naze32 hardware discussion thread
thx timecop, easy. @ytheleus: i also do not have much experience, wheter practical nore theoretical. I only tried it on the pin board with one motor. In the simulation I used afaik 1000µF capacitors which flated the voltage curve down with a response time of like 1ms. Without capacitors there were i...
- Mon Jul 08, 2013 10:20 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1451367
Re: Naze32 hardware discussion thread
One more thing: Can I connect a 1s LiPo directly to one of the BEC connections on the Naze or is this to low or unstable? I didn't think of 5V at any time of the planning since the stm32 runs at 3,3V anyway... ytheleus: I don't even think you need capacitors. nFETs should survive that and motors be ...
- Sat Jul 06, 2013 12:37 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1451367
Re: Naze32 hardware discussion thread
Thx, I'll give it a try and report when tested. of course: us, not ns...
- Sat Jul 06, 2013 12:23 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1451367
Re: Naze32 hardware discussion thread
Thank you,
Since I already set all up, no i don't mind. Couldn't hurt to learn how to compile some powerful ARM processors.
But to be clear: the values are always supposed to be in nanoseconds, independet from the PWM rate?
Since I already set all up, no i don't mind. Couldn't hurt to learn how to compile some powerful ARM processors.
But to be clear: the values are always supposed to be in nanoseconds, independet from the PWM rate?
- Sat Jul 06, 2013 11:57 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1451367
Re: Naze32 hardware discussion thread
Hi guys, first thing I'm new to RC so forgive me my noobism please. I'll try my very best to only ask question I cannot figure out myself or to be sure respectively. I'm planing to build a tiny little nanoquad with brushed motors, because i have used Naze32 before and I liked, I ordered a bunch of A...