MultiWii

I'd like to do auto-level. I can enable angle, horizon, baro and Mag. I've seen a few talk about ACC, what is that? Would GPS enabled help with auto-level, or would I just use that for loiter? what I assume is: angle, Horizon, and baro would enable loiter (and mag would help with head-hold). Can any...

Should I expect to see some indication that 'calibration' is going on, after I upload 'ESC_CALIB' to the controller? The last time I did this, I don't think it did anything.. No beeps, not much of anything.

I'm having the same problem.... I use Min Throttle + Full right yaw, and in the GUI, it says "Armed". At that point in the GUI, I can see throttle response coming from the MultiWii, (the bar graphs rise and fall on command), but none of the motors spin up. The motors run fine when hooked u...

how do I sync the escs? None start. I've modified the code, lowered the 'start' value, set my RX so that the minimum is below 1000, changed the update speed from 400hz to 100hz, still no joy.

I'm having the same problem. I've adjusted my throttle stops on my tx so that the gui indicates 'armed', and 'disarmed'. Easy.
I'm still not getting 'beep' from the motors, nor motor-start. Ideas? Turnigy ESC's,
I'd also like to calibrate the esc's.... Any idea how to do this?