MultiWii

Hello! Just changed my Cc3d firmware from Openpilot to Cleanflight (latest Betaflight). With Openpilot was using Minoposd fw to read flight battery voltage hooked up with voltage divider to Atmega Adc6 (pin19). Now changed minimosd fw to latest R1.5. But i cannot read voltage anymore, because as i s...

@aftershocker... my only thoughts are - overlooked something in wiring (doesn't sound like it) or maybe if using the 5v to power the output stage of the minim its too much power for that + 5v cam? Fatshark cam gets +5v from fatshark transmitter, but tried to power from flight controller Ubec, also ...

@aftershocker - for your issue - have you checked pinouts on your chinese cam is same as IRC ones ... Mine are not same.... especially the power pins Thanks for reply! With pinouts everything is ok, chinese cam have 12v supply and fatsharks have 5v. Otherwise i had something burned . Also i power e...

Reply to my question! There is not problem with Fatshark camera, but with transmitter! Connected Fatshark camera - minimOsd - simple Chinese transmitter and everything works fine. So there Fatshark transmitter does not like MinimOsd. Been reading there are something to do with white balance in the m...

Hi! Think this is not right topic to write my problem, but i am using this firmware on Minim osd 1.1. It is working well, still need more free time to play with it. First i started to use it, i was thinking it is compatible with Multiwii 2.3, but seems not, works ok with 2.2 version. When will be up...

One more thing need to be done is to cut Sj2 and Sj3 jumper pads. Can you please post some pics of the mod ? Here are my picture. You need to cut between mid pad and the right one on sj2 and sj3. Be very careful. And as JDD posted for other boards like from Hobbyking(not all in the program listing)...

Yes, i did that! And my external mag is working fine when it is away from all the wiring. One more thing need to be done is to cut Sj2 and Sj3 jumper pads. This disables onboard mag chip. Need to be done very carefully with manifier glass and small sharp hobby knife. I have tried to uncomment that o...

Hello! The same happened to me yesterday. MWC 2.2 software and Crius aiop board. Gps, bluetooth, hovering and flying works well, no wobbles. Then i tried first time AltHold, also holds altitude +- 1meter, think this is good. Then switched Headfree and Mag mode, Althold still working, copter did not ...