Search found 9 matches

by ebourlet
Wed Mar 20, 2013 5:27 pm
Forum: ESCs, propellers , servos and radios
Topic: Alternative ESC firmware (reflashing)
Replies: 640
Views: 338021

Re: Alternative ESC firmware (reflashing)

Thank you I found it from last November "Using multimiter, you can find them checking connction between pin 19, 22, 23 of the MCU". Sorry I should have read the entire thread first. I did try searching but apparently not for the right info. http://i104.photobucket.com/albums/m171/ebourlet/...
by ebourlet
Wed Mar 20, 2013 4:03 pm
Forum: ESCs, propellers , servos and radios
Topic: Alternative ESC firmware (reflashing)
Replies: 640
Views: 338021

Re: Alternative ESC firmware (reflashing)

There is a good photo here http://static.rcgroups.net/forums/attac ... %20row.jpg where should I ask to get someone to point out the right ones? Thank you
by ebourlet
Wed Mar 20, 2013 8:02 am
Forum: ESCs, propellers , servos and radios
Topic: Alternative ESC firmware (reflashing)
Replies: 640
Views: 338021

Re: Where are BEMF on nfet HK blue series

I have this ESC http://static.rcgroups.net/forums/attachments/1/0/5/5/0/5/a4614446-81-own%20BS30A%20pads%20not%20in%20row.jpg unfortunately I flashed with SimonK before I figured out the NTM motor will not work. Flashed with Wii BSNFET and it stutters will not run. Can anyone tell me how to find wh...
by ebourlet
Wed Mar 20, 2013 7:59 am
Forum: ESCs, propellers , servos and radios
Topic: Alternative ESC firmware (reflashing)
Replies: 640
Views: 338021

wii-esc-2013-02-15.zip ?

I just flashed my HK Blue series N-FET with the low side pwm bs_nfet.hex file . I have a 2826 1000kv NTM motor. It appears to work fine . My question is it required to remove the BEMF caps? I can't find any information on where they are on this ESC and I can't find anything not working with this set...
by ebourlet
Wed Mar 20, 2013 7:03 am
Forum: ESCs, propellers , servos and radios
Topic: Alternative ESC firmware (reflashing)
Replies: 640
Views: 338021

Where are BEMF on nfet HK blue series

I have this ESC http://static.rcgroups.net/forums/attachments/1/0/5/5/0/5/a4614446-81-own%20BS30A%20pads%20not%20in%20row.jpg unfortunately I flashed with SimonK before I figured out the NTM motor will not work. Flashed with Wii BSNFET and it stutters will not run. Can anyone tell me how to find wha...
by ebourlet
Tue Mar 12, 2013 5:03 pm
Forum: Software
Topic: Crius MultiWii v0.2 GUI 2.1
Replies: 6
Views: 4238

Re: Crius MultiWii v0.2 GUI 2.1

I just got the Hobbyking 328 P with FTDI board. When I took it out of the bag and hooked it up all of the channels in MultiWii GUI were stable. After flashing with the recommended settings from the files section on the hobbyking site with 2.1 now the Aux 2 values jump all over.
by ebourlet
Tue Mar 12, 2013 8:58 am
Forum: Ideas
Topic: wishlist for v2.3
Replies: 104
Views: 43339

Re: wishlist for v2.3

Failsafe descent rate based on barometric pressure sensor based rate of descent rather than preset min throttle + set value.
by ebourlet
Tue Mar 12, 2013 6:15 am
Forum: Software development
Topic: MultiWii 2.2 is released
Replies: 84
Views: 60956

Re: MultiWii 2.2 is released

Sorry if this is the wrong place for this. I am new and just got the HK 328P ftdi board. I selected #define HK_MultiWii_328P // Also labeled "Hobbybro" on the back. ITG3205 + BMA180 + BMP085 + NMC5583L + DSM2 Connector (Spektrum Satellite) Ok got 2.2 uploaded to the board by using Arduino ...
by ebourlet
Tue Mar 12, 2013 5:45 am
Forum: Getting Started - MultiWii config and setup
Topic: problems flashing 2.2 to HK328P
Replies: 1
Views: 987

problems flashing 2.2 to HK328P

I get the following errors when I try to flash my HK Multiwii 328 P MultiWii.cpp: In function 'void setup()': MultiWii:715: error: 'readEEPROM' was not declared in this scope MultiWii:717: error: 'readGlobalSet' was not declared in this scope MultiWii.cpp: In function 'void loop()': MultiWii:1014: e...