MultiWii

Thank you I found it from last November "Using multimiter, you can find them checking connction between pin 19, 22, 23 of the MCU". Sorry I should have read the entire thread first. I did try searching but apparently not for the right info. http://i104.photobucket.com/albums/m171/ebourlet/...

There is a good photo here http://static.rcgroups.net/forums/attac ... %20row.jpg where should I ask to get someone to point out the right ones? Thank you

I have this ESC http://static.rcgroups.net/forums/attachments/1/0/5/5/0/5/a4614446-81-own%20BS30A%20pads%20not%20in%20row.jpg unfortunately I flashed with SimonK before I figured out the NTM motor will not work. Flashed with Wii BSNFET and it stutters will not run. Can anyone tell me how to find wh...

I just flashed my HK Blue series N-FET with the low side pwm bs_nfet.hex file . I have a 2826 1000kv NTM motor. It appears to work fine . My question is it required to remove the BEMF caps? I can't find any information on where they are on this ESC and I can't find anything not working with this set...

I have this ESC http://static.rcgroups.net/forums/attachments/1/0/5/5/0/5/a4614446-81-own%20BS30A%20pads%20not%20in%20row.jpg unfortunately I flashed with SimonK before I figured out the NTM motor will not work. Flashed with Wii BSNFET and it stutters will not run. Can anyone tell me how to find wha...

I just got the Hobbyking 328 P with FTDI board. When I took it out of the bag and hooked it up all of the channels in MultiWii GUI were stable. After flashing with the recommended settings from the files section on the hobbyking site with 2.1 now the Aux 2 values jump all over.

Failsafe descent rate based on barometric pressure sensor based rate of descent rather than preset min throttle + set value.

Sorry if this is the wrong place for this. I am new and just got the HK 328P ftdi board. I selected #define HK_MultiWii_328P // Also labeled "Hobbybro" on the back. ITG3205 + BMA180 + BMP085 + NMC5583L + DSM2 Connector (Spektrum Satellite) Ok got 2.2 uploaded to the board by using Arduino ...

I get the following errors when I try to flash my HK Multiwii 328 P MultiWii.cpp: In function 'void setup()': MultiWii:715: error: 'readEEPROM' was not declared in this scope MultiWii:717: error: 'readGlobalSet' was not declared in this scope MultiWii.cpp: In function 'void loop()': MultiWii:1014: e...