MultiWii

my ide is arduino 1.6.1
Thanks

the ide does not compile if activate: #define SERVO TILT Shows the following error: In file included from Output.cpp:3:0: Output.cpp: In function 'void __vector_14()': def.h:1431:38: error: 'PORTL' was not declared in this scope #define SERVO_1_PIN_HIGH PORTL |= 1<<5; ^ def.h:683:24: note: in expans...

if it gets hot?
We have a fan?

It is possible can create the code to use two redundant Fc?
In Italy it is required to approve drones.

a question, Upload Firmware at the air modul,how do you proceed?
Thanks

a question:
because in psh if I move the stick with the quad when I leave the stick back to the point where I had activated the psh?
It should not change the psh if I leave the stick?

a question:
How do you trim the accelerometers?
In the same manner of a multicopter?
Because the rudder corrects me and always wants to keep the bow although I have not activated the mode in Mag?

One question: Use horizont instead of angle, that's fine too?

This morning, the first mission, no problem everything is perfect!
Wonderful job!
I made a donation for your work
Thanks

I tried with my quadx "with CRIUS AIOP" the MultiWii 2.3 navb1: it tends to turn on itself, you can not fly. The wingui2.3 pre4 does not make me select the waipoints with double click,i use windows8 thanks Read the first post, you can put down waypoints with shift+left click. Double click...

I tried with my quadx "with CRIUS AIOP" the MultiWii 2.3 navb1: it tends to turn on itself, you can not fly.
The wingui2.3 pre4 does not make me select the waipoints with double click,i use windows8
thanks

still not solved the problem with Crius aiop v1.1 and CN-06 GPS Receiver V2.0, does not recognize the GPS and the LED remains fixed access only after resetting "card powered" recognizes and executes the GPS fix . I have had the same config like you. MWii 2.2 GPS was working every time. Wi...

still not solved the problem with Crius aiop v1.1 and CN-06 GPS Receiver V2.0, does not recognize the GPS and the LED remains fixed access only after resetting "card powered" recognizes and executes the GPS fix .

-1

The truth is that ported to C + + has been hurt and does not work, not even to me that I have a CRIUS aio.
I use the 2.2 for now and until the EOS does not put his hand to the code will not use the new relase.

I discovered the solution to the problem of the fix for FC CRIUS aio.
Need to be reset after the first power in practice as it had done before EOSBandi not alter the gps.ino sending a session string to the GPS turned on.
I wonder will lost it ported?
EOSBandi help!

Sorry for my English.
I have a problem with the GPS.
Using a quad with Crius AIO v1, do not you start searching for satellites, the LED remains lit, if I plug socket usb to pc starts blinking to find satelliti.e after it all works.
With 2.2 everything is ok.
thank you very much