MultiWii

Thank you. After setting sub trim and end points I can start the motors. I cannot set endpoints to 2000 but I found that 1940 will do too. I guess otherwise I would have to change max values in CLI. Since I connected all motors the same way, they are all spinning in the same direction. Can this be f...

Receiver is only powered when 5v from bec is available, not by USB alone. Then you will see channels in the GUI. Endpoints, trim are in the radio. You don't need to scope anything Ah ok, Now I see channels moving in GUI according to stick movement on transmitter. I can go from here, I guess. I read...

Ok, I see. ppm feature in CLI has to be disabled. But where do I set endpoints? In CLI or on transceiver? Same question for sub trimming. Probably I have to set the transceiver correctly that the transmitted signals are on the correct channels. Any tip how to check if anything is transmitted? With s...

Are you refering to this manual?
http://www.abusemark.com/downloads/naze32_rev2.pdf
I don't find in it there...
Probably because I don't know where and how to set...
I might be so obvious to you, but I don't know what to do next.

So I guess ppm in the CLI stands for cppm...

Hello guys, I'm very new to RC stuff and build a quadcopter with a white Naze32 board (terminal version says: Afro32 CLI version 2.1 Nov 12 2012 / 17:35:15) . - 30A ESC (FH-30A UBEC)) from Abusemark with SimonK firmware - Turnigy D3530/14 1100KV - Turnigy 9x - Turnigy 9X8C v2 receiver it has no sums...