MultiWii

hi every one



that is very good

hi everyone my sfr08 does not work correctly. i change the address to true one like raptor said before ( i have (1 long flash and 6 short flashes) means EC in hex address and i change it to 0x76)) but i don't see any effect in my multiwii config program raptor said by enabling debug 3 we should see ...

i wish the new version of multiwii means 2.3 write with the baud rate menu like wingui program for selecting different value of baud


and using ultrasonic sensor for auto landing procedure !!!!

hi every one

i used mtk3339 it works correctly.

Yes I used 19200 baud rate and by xbee pro module i transmit data in 3550 m without any problem with no error. I know the cpu using interrupt for sending data but it should wait to transmitting be complete and then running the next step. during this time cpu is busy and i want to know why the contro...

hi everyone i connect my xbee pro module to my promini board and i receive data without any problem in 19200 baud rate BUT !!!! would you mind explaining for me how is it possible to send this volume of data (256 byte) online and the refresh rate of control loop doesn't change!! for sending this dat...

dear crashpilot
I change both speed to same value but the error still here!!!!
I will change the 10k to your suggestion and i will report the the result

Please HELP

would you mind helping me please

HI Everyone my GPS module is EB-85A from Etek navigation company. in test when i connect my board(with your i2c-gps-nav Ver:V2-2) to multiwii(dev_r1317) the i2c errors happen i don't know how should i solve this problem my internal pull up is De active and i use two 10K ohm resistor for external pul...

HI Everyone my GPS module is EB-85A from Etek navigation company. in test when i connect my board(with your i2c-gps-nav Ver:V2-2) to multiwii(dev_r1317) the i2c errors happen i don't know how should i solve this problem my internal pull up is De active and i use two 10K ohm resistor for external pul...