Search found 6 matches
- Sat Feb 02, 2013 7:35 pm
- Forum: Shields, boards and sensors
- Topic: updated firmware for the Jakub/Kuki board
- Replies: 2
- Views: 1308
Re: updated firmware for the Jakub/Kuki board
Firmware 2.1 from FC Kuki is here http://telnet.r-ce.pl/quadro/multiwii/MultiWiiConf_2_1_063_full.zip
- Tue Jan 22, 2013 9:04 pm
- Forum: Software development
- Topic: MultiWii EZ-GUI
- Replies: 1434
- Views: 731049
Re: MultiWii EZ-GUI
You can not easily change the Bluetooth module of the Master to Slave.
Descriptions of how to do the network can be found.
It is easier to buy a set of factory module.
Select a module of an Internet address:
http://www.ebay.com/sch/i.html?_trksid= ... &_from=R40
Descriptions of how to do the network can be found.
It is easier to buy a set of factory module.
Select a module of an Internet address:
http://www.ebay.com/sch/i.html?_trksid= ... &_from=R40
- Tue Jan 22, 2013 11:13 am
- Forum: Software development
- Topic: MultiWii EZ-GUI
- Replies: 1434
- Views: 731049
Re: MultiWii EZ-GUI
Bluetooth should be a SLAVE, then this works fine.
You probably have a MASTER.
You probably have a MASTER.
- Wed Dec 26, 2012 8:25 pm
- Forum: Software development
- Topic: MultiWii EZ-GUI
- Replies: 1434
- Views: 731049
Re: MultiWii EZ-GUI
I have a Samsung GT-i5700 "SPICA" with Android 2.2.2 2.92 For applications did not show me the data of satellites and Graphs did not work. After an exchange of correspondence with the EZIO received from him a revised application code. Now correctly shows the data related to satellites and ...
- Thu Dec 20, 2012 3:08 pm
- Forum: Software development
- Topic: MultiWii EZ-GUI
- Replies: 1434
- Views: 731049
Re: MultiWii EZ-GUI
After further tests, I noticed that at the time when my model show from 3-6 GPS satellites, and when the USB Configurator Multiwii show the detected amounts are in your 2.91.45 did not showed. Also used the OLED display and another application called Naze 32 Configurator and there also were shown an...
- Sun Dec 09, 2012 5:19 pm
- Forum: Shields, boards and sensors
- Topic: I2C OLED thread
- Replies: 62
- Views: 61273
Re: I2C OLED thread
RESET pin should be pin 14 of the 30 pin flat cable.
On the photo you can see that you have used the pin 13.
On the photo you can see that you have used the pin 13.