Search found 6 matches

by jlouden
Mon Feb 04, 2013 9:16 pm
Forum: Getting Started - MultiWii config and setup
Topic: Position Hold never seems to work?
Replies: 6
Views: 2500

Re: Position Hold never seems to work?

I have the same configuration as you and have had similar problems. I have been waiting for some decent weather to try again. I did get my RTH to kind of work. It headed back to my position but did not stop there. Using multiwiiEZ I can see the progress on the map so I know the GPS is reading correc...
by jlouden
Mon Feb 04, 2013 9:11 pm
Forum: Getting Started - MultiWii config and setup
Topic: Multiwii 2.1 GPS hold functionality
Replies: 2
Views: 1375

Re: Multiwii 2.1 GPS hold functionality

Thanks. That is what I hoped it would do.
by jlouden
Wed Jan 30, 2013 12:30 am
Forum: Software development
Topic: MultiWii EZ-GUI
Replies: 1434
Views: 625615

Re: MultiWii EZ-GUI

Hi, Has anyone done a meter (cm) to feet conversion for this app?

John
by jlouden
Fri Jan 25, 2013 9:52 pm
Forum: Getting Started - MultiWii config and setup
Topic: Multiwii 2.1 GPS hold functionality
Replies: 2
Views: 1375

Multiwii 2.1 GPS hold functionality

I have been trying to find the parameters that the GPS Hold works under but have seen different information. When you make the GPS hold function active, does it use the current GPS coordinates to hold or does it use the location when the copter was armed? I would like to have my copter hold the curr...
by jlouden
Thu Jan 10, 2013 1:58 am
Forum: Shields, boards and sensors
Topic: I2C OLED thread
Replies: 62
Views: 58901

Re: I2C OLED thread

I just found the problem. I had to turn up the end points on my XMTR to get the board to recognize the commands.
by jlouden
Thu Jan 10, 2013 1:36 am
Forum: Shields, boards and sensors
Topic: I2C OLED thread
Replies: 62
Views: 58901

Re: I2C OLED thread

I have one of the Crius boards and I get the top two lines on the display. I can change the text so I know I am communicating. I can't get the board to show anything else. I have tried different combinations of settings in the telemetry section but nothing seems to make any difference.

Any ideas?