MultiWii

EOS Bandi has done great here in GPS. in an open soures project should not be dependent on a person everything.   there are many people who also can use this. only should be accepted. Multiwii is good, it has to be better, it can only create the community. MAV-link projects are everywhere. why not m...

Congratulations to the waypoints.
great work

GPS and althold have defects, only when these are resolved, the Waypoint Navigation ok.

APM works great and multiwii with Arducopter GPS code? why not! is OK

Dear all- I just installed 2.2. (Setup: Crius AIO Pro, Simon K ESCs, Y6 cinfiguration, 8" props, Oled, CRIUS V2 GPS). It flies nicely, GPS PH is awesome- BUT I have all 0.8 to 2 sec small "twitches" i.e. one (or may be 2 motors on one arm?) speed up for a very short time such a way t...

Hello loaded the new Version2.2, up to the level control all OK. The problem: the throttle is at the bottom, so the engines are off, now the barometer is enabled to run the motors at once, so that the copter almost apart. The next problem: one has accidentally activated the Baro and turns the copter...

Hello

Altitude Hold security gaps.
if altitude gets activated to run the engines, is the throttelstick a little on gas and altitude activated lifts off the copter.
This is very dangerous

timecop wrote:Because there'd be too much shit to #ifdef on a tarduino pro mini.
And the second reason is that qgroundcontrol is fucking HIDEOUS.
Worse than multwiiconf, by far.

Hello

I am convinced of Multiwii, but I have recently MAVLINK geladen.es works far better than Multiwii. I am amazed.

Hello can please help me someone to take my GPS Modul module "I2C PA6C GPS + LLC breakout board 3, 3/5V by Drotek" into operation? I read a lot of threats here, but I’m still unsuccessful. I’m using the flight control board "MultiWii 328 p flight controller w/FTDI & DSM2 port&quo...

if we look back once a year and Multiwii compare to him stood from today.

there has been performed very much a lot, my thanks go to the developers.

one should not be also forgotten the people have seated its spare time for it.

Thanks for this excellent work.

Please, calibrate the Gyro and the ACC

Hello I have a problem with the camera Gimbal. The Gimbal is connected to pin 44 and 45 on the Mega. The receiver is PPM. How I can lay the Gimbal on other pins Pin 44 and 45 is has booked no other possibility to connect how can RCDATA be issued. the stabilization should be automatic, without contro...

Hello, to begin thanks for this software, a wonderful work. mine asks filter to the GPS up to now I have used with an I2C GPS the #define GPS_FILTERING, I have not used the other and have made good experience with it. with serial GPS I use him #define GPS_LOW_SPEED_D_FILTER or is it better to be cho...