MultiWii

Hi,

some people are writing about using EZGui with another baudrate than 115200. But even after reading through many pages of this thread, I can't figure out how to change the baudrate of EZGui.
I'd like to connect a BT-APC220-Bridge which is running at 19200bps.

Has anybody considered taking a TX module from an RCSet and feed that with Signals from an Arduino connected to a PC?
Doing it that way, it should be pretty fast and one can use the available RC-Equipment with very good range.

Andreas, take a look at this and load the loaded the config file to the GPS. It worked for me with a similar problem. http://www.multiwii.com/forum/viewtopic.php?f=8&t=3431&start=40#p36407 Yeehaa, it works now after configuring the Ublox with that config. Thanks a lot! Ublox accuracy is eve...

Hi Guys, I've a strange problem with my UBlox GPS from RCTimer. If I power the Crius AIO with the USB connector and start MultiWiiConfig, GPS data is received and I get a satfix. If I power the FC with the Lipo, I don't get data and satfix - but the GPS Module gets proper power. It comes with defaul...

Hi,
what kind of Hardware are you using to communicate with the Android device? Is there anything like a wifi2uart adapter?

That would be interesting for ezgui, too.

Regards
Andreas

That's interesting, since I still have problems with pitching the copter along the W-E Axis. Mag heading is always drifting away.

Seems like that code snippet works in WiiCopter-Code. Are you using it like that?

What is the pain when you reflash it? It should be a matter of 20 seconds?

Had the same problem with my MBP. I used a cheap external BT dongle which worked fine, like USB. After upgrading to Mac OS X 10.8 from 10.7, internal BT is fast, too! Which Mac OS are you using? If you have 10.7, I would recommend 10.8. If you have 10.6, kepp it as long as possible and get a BT adap...

Hi Guys, this is very creditable. But I'm not sure if it will be better to make a complete new project out of that - or (even better in my opinion) contribute at one of the great existing projects like MPNG. One thing I really like concerning MWii is the overall simplicity of the code. Since the Gui...

I have a very similar problem. But even in MultiWiiGui, I can see MAG turning a little when I pitch/roll the flightcontroller. During flight, I can see the same problem you describe. I have the same problem with a Crius SE and a Crius AIO, so I assume the hardware is ok. First, I thought it would be...

Power trick helped me quiet often.

Power on the GPS AFTER hitting "Download".
I flashed 3329 fw to a 3339 and rescued it that way.

Hi, I'm trying to set my Drotek PA6C to 10Hz / 115.200, but it always outputs nonsense after doing that. I tried: -Setting 115.200 in MiniGPS. After that, and setting the comport-speed to 115.200 as well, I only receive rubbish. Setting back doesn't work, only way is to remove the battery. -Setting ...

RTFM
http://www.multiwii.com/

Alive again

I set the update baudrate to 9600bps, prepared everything, clicked "Download" and powered on the GPS shortly AFTER clicking. That did the trick. Upload worked fine and it is alive again!

Hi, I've exactly the same problem. I updated a Pa6C from drotek with the 115200 Firmware. FlashTool said success, LED blinks, but I only get rubbish from the serial port at all baudrates from 4800 to 115200. Looks like the module is set to a baudrate I can't configure or something like that. I tried...