Search found 8 matches

by davidwp56
Fri Mar 01, 2013 11:37 pm
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

Does it really cost more than $4 flat rate shipping to bumfucknowhere USA!!??
by davidwp56
Tue Oct 16, 2012 5:36 am
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

I had this when using the plush ESC's, erratic starting and speed on differant motors, set min throttle to 1200 (as per timecops advise) and solved the problem.

regards.
by davidwp56
Sat Sep 22, 2012 1:47 pm
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

timecop wrote:you need feature telemetry on as well



Thanks TC,
Knew it would be something dumb.

David.
by davidwp56
Sat Sep 22, 2012 12:23 pm
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

(posted @ rcg) If anyone else can help me out with this it would be appreciated, just need to know how the Frsky D4R-ll receiver can be hooked up to the board with telemetry adapter. There's pinout on the bottom of D4FR-II. RX/TX/GND/A2 or something similar. Wire up the frsky adapter as shown in th...
by davidwp56
Mon Sep 17, 2012 9:34 am
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

This gets more interesting. With either a DSM2 and DSMX satellite, it works perfectly if I turn on the FC board/Satellite first, followed by the TX. With the reverse power up sequence, it looks as if the satellite is not getting a valid signal. It, along with the TX must be powered down, and then t...
by davidwp56
Mon Sep 17, 2012 9:27 am
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

(posted @ rcg) If anyone else can help me out with this it would be appreciated, just need to know how the Frsky D4R-ll receiver can be hooked up to the board with telemetry adapter. There's pinout on the bottom of D4FR-II. RX/TX/GND/A2 or something similar. Wire up the frsky adapter as shown in th...
by davidwp56
Mon Sep 17, 2012 3:19 am
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

John, I had similiar problems with this when using 5volt supply. I ended up using the OP spektrum adaptor to supply 3.3?volts and from that point on has been 100% reliable. For whatever reason the higher voltage caused erratic behaviour. David. spektrum sat is a 3v device, I'm surprised it still wo...
by davidwp56
Sun Sep 16, 2012 11:42 pm
Forum: Boards
Topic: Naze32 hardware discussion thread
Replies: 3249
Views: 1377205

Re: Naze32 hardware discussion thread

Question for any Spektrum Satellite users: I can take a DSM2 satellite, and bind it to my TX, either with a receiver or via an Arduino sketch. I then hook it up to the Naze, powerup, and it works fine, once. At the next powerup, the Satellite goes back into bind mode. I've tried setting the GPIO in...