MultiWii

Hi,
can someone describe or show me an example of how to use the I2C GPS
can read. On the module of Drotek is the 2.1 firmware from it EOSBandi.
I need the distance to the home point and the direction and the current position (Long & Lat)
Any help would be greatly appreciated.

Thanks for the link, I'll look at you You're right, once set, the controller indicative of the normal case. Then I'll take the controls again and the Flydumini external program. Danke für den Link, werde ich mir mal anschauen Du hast recht, einmal einstellen der Regler richt im normalfall aus. Dann ...

Hello, the SimonK are of course a great thing. But I have installed on my Little Copter the XP-7A. Have the Sil µC and unfortunately goes no SimonK Programming card is also bad because the ESC's are soldered and the Arduino also. @ Lenzz thanks for the link. As I have previously written my Programmi...

LenzGr wrote:

Scotch wrote:... Are you looking into using an Arduino board to replace the programming card?

Hello Lenz,
your assumption is correct.
Often motors and ESC are installed permanently (Soldered)
Then a softwar solution would be ideal for settings to be changed later.
Regards
Ingo

Hello Hamburger, thanks for your answer. If I understand correctly, so I can only but prorammieren the gas path. But I want to change all the settings from the ESC. Now I'm also a bit more came forward. I have a 1.8 so far compressed that I have the data from the spectrum satellite can output via se...

Hello, it is possible that THROTTLE signal, 1 to 1, by forward to one or all engine outputs? Then you could at the same time so that all ESC programming. Especially the use of satellite receivers that would be very helpful. Even an extra program for the Arduino would help me a lot. The attempts to r...