MultiWii

Following all your advice and Chris kindly sending me a new sketch file, just uploaded and had 10 mins tinkering with the PID settings, not only is it off the ground, but its like a new quad!!!! So stable in the hover, can throw it around and its like its on rails!! Thanks for the advice and HUGE th...

Also, when I upload the sketch file with arduino, then run the 2.1 GUI, everything is fine, but if I disconnect the lead then reconnect, the GUI wont read the board??

I cannot thank you guys enough........I know have all sensors showing on the graph!!

I just have to set it up and fly now

I am using a spektrum AR6100 rx that I used on the KK board, can I connect it the same way, a 3 pin cable for each channel (throttle,ail,elev and rudd)?

Thanks for the replies guys, I was nearly at the point of finding a brick wall to bang my head against!

I'll try the 2.1 and see if can manage to sort it

Chris, thanks for the kind offer. If I cant sort it I'll pm you

Thanks again

Update.. With arduino I have selected board as Arduino nano w/ ATmega 328, opened multiwi_1_9.pde and uploaded, closed arduino and run 1.9 gui and it only logs the 1 channel as described above. I cannot calibrate mag or acc and am completely stumped!! What worries me is there is very little informat...

Hello all I need help with my multiwii board please I have just replaced my KK board with a multiwii and am having real trouble with getting it set up properly. I have arduino and multiwii v1.9 software and initially set up the board in the GUI, calibrated ESC's, acc, mag and all 'channels' and moto...