MultiWii

arne wrote:Disable the "telemetry" feature, then the OSD should work when the copter is armed.

Thanks, can't believe it was that simple I spent hours going through the osd code .

Hi, still doing some tests to get the minimosd working with my naze32 board. Almost everything works now fine, GPS, PID, Altitude and artificial horizon. But if i arm the motors the osd freezes if i unarm everything works again. I tested this also with the MW-WinGUI all sensors are read correct but ...

Hello Ross,

Thanks, will give that a try.

Hi, i am trying to get the Rushduino/Minimosd to work with my Naze32 board. Everything seems to be working fine, like GPS, Vbat and the angels. But for some reason the OSD does not get armed. If i use the Yaw stick to start the motors the osd still shows disamed and the timers don't start. Same OSD ...

Thanks, but It seems the new Rushduino software is already using the new MSP Protocol.
I will check in the Rusduino thread if they know why the naze board does not arm.

Hello TC, I am not sure about the protocol. As far as i know the rusduiono osd get it's data form the LCD_TELEMETRY. As most of the data is displayed correct i presumed it was the same for the naze board. On my crius board it works OK and arms the OSD. It would be nice to get this working, a minimos...

I am trying to get the rushduino/minim osd boards to work with the TX/RX out on the naze board. Most of the things like GPS, altitude and the angles work just fine. But if you arm the copter and the motors start spinning the OSD is not getting a signal to arm and stay's in disarmed mode. As far as i...

Hi Kataventos, Got most of the things working with your latest version and it is a lot faster ! But i have some trouble with the voltage messurment, I am messuring the 12 volt video voltage on Port 0, but all messurements will give me a value of 1023. With the old rusduino software the voltage was ...

Hi Kataventos, Got most of the things working with your latest version and it is a lot faster ! But i have some trouble with the voltage messurment, I am messuring the 12 volt video voltage on Port 0, but all messurements will give me a value of 1023. With the old rusduino software the voltage was c...

This is great news, thanks for developing the rushduino/minimosd software!! It's been quiet way to long!!!
I love this little osd, it's light/cheap and uses the existing hardware !

Thanks, will order one from rctimer

Thanks, was already afraid for that.
Would the rctimer Multiwii FC I2C-GPS NAV Module work with my gps?
(http://www.rctimer.com/index.php?gOo=go ... oductname=)

I bought an Neo 6u-blox gps from ebay with serial and i2c connection; (m) Serial conection is working just fine, changed the baud rate and get a gps fix realy fast. But as i have a Crius SE i would rather use the SDA/SCL pins to connect it to my crius board by i2c . At the moment it's not working i ...