MultiWii

Had the same problem after connecting my old MultiWii Kopters over Windows 10 or Windows 11.
The problem is: the Java installed is to new.
You need to install an older Java (had success with Java 8.202)
Then open the GUI, choose Comport, hit start, and it's working like old times

I also have this problem on some of my 328p boards (not all). there is apparently a problem with NO_FLASH_CHECK activate #define NO_FLASH_CHECK and it should be good after a proper reset. this works: //#define NO_FLASH_CHECK //#define MULTIPLE_CONFIGURATION_PROFILES Thanks Alexinparis and Hamburger...

have tested in R1573 and right now in R1604 to save in the GUI "Settings page" some values. First, i found VBATscale was not saved, but then tried other "green" values in this page: Mintrottle / vbatscale / MAG DECL and none of them was sucessfully saved with write after changed....

Hi can anyone tell me where i can find the newest I2C GPS Nav code for the newest Mwii dev ? on the googlecode site from eosbandi i can only find r33 , but i have read about a the new nav rate controller and cant find it . thanks that would be interesting for me, too Have working serial GPS with de...

I have several versions of FW for a 3329, not sure if DGPS is enabled or not but, you are welcome to try them. I cannot flash my unit, I always get a sync error. thanks, surely I will try them, I will sent you a pm for that in my other thread I have learned, that CTRL + ALR + S will permanently sav...

Hello, I search a way to permanently write settings into the Meditek 3329. Have successfully flashed 10Hz / 115200 Baud firmware and my Kopter is flying ok for GPS PH or CH, but I want to set it permanently to 5Hz and using DGPS for a more precise Position. In 10 Hz Mode no DGPS is possible. I used ...

Thanks all. I am unable to successfully flash the firmware on my MTK3339 based SKYLAB SKM53 module. I can change the setting with Mini GPS but they revert back to default (9600, 1Hz) after several hours. In the latest DEV, where would I send init strings to set it back to 115,200 10Hz? My questien ...