Search found 5 matches
- Tue Jun 26, 2012 11:16 pm
- Forum: General discussions
- Topic: Help - Yaw and pitch reversed only to motor output
- Replies: 60
- Views: 19743
Re: Help - Yaw and pitch reversed only to motor output
tried changing the channels in your TX? In my hitec aurora I had to switch the elevator and rudder between 2 and 4. So not switching the sticks but the actual channels.
- Sat Jun 23, 2012 11:00 am
- Forum: General discussions
- Topic: Quadrino & Hitec SPC
- Replies: 0
- Views: 806
Quadrino & Hitec SPC
Hey Guys, Does anyone have experience with connecting a hitec receiver to a quadrino (zoom)? I want to connect the SPC port so I can monitor the voltage on my TX. At the moment I power the board through the motor pins and have a power+ground wire from the control pins to the RX to power it. I think ...
- Sat Jun 23, 2012 10:43 am
- Forum: Software development
- Topic: mobiDrone nano arduino OSD for MultiWii with PID config
- Replies: 295
- Views: 129835
Re: mobiDrone nano arduino OSD for MultiWii with PID config
Gratz on making the exam and getting the job!
How do I add both the GPS + OSD? Just parallel solder it? I only got 1 set of pins on the board.
How do I add both the GPS + OSD? Just parallel solder it? I only got 1 set of pins on the board.
- Thu Jun 21, 2012 8:05 pm
- Forum: Shields, boards and sensors
- Topic: NanoWii atmega32u4 (leonardo) FC
- Replies: 52
- Views: 43620
Re: NanoWii DIY FC
great job! I will order one soon to build a nano quad once I found a proper frame (like the guys are making here: http://www.rcgroups.com/forums/showthre ... wii&page=7)
- Thu Jun 21, 2012 7:40 pm
- Forum: Software development
- Topic: mobiDrone nano arduino OSD for MultiWii with PID config
- Replies: 295
- Views: 129835
Re: mobiDrone nano arduino OSD for MultiWii with PID config
Hi there, I'm looking for a OSD that I can use to read my board + additional sensors so I dont need all double sensors. But I'm new to all of this so here is a newb question: I ordered a quadrino zoom (m) + I2C GPS (m) Is it possible to add this OSD and read all the data from the board? Regards, Bas