MultiWii

Did you crashed to power line like I did? LOL.

http://www.youtube.com/watch?v=gaEkENn2H2I&feature=plcp

Changed mine, feels better. I want to eluminate any wobble during fast forward.

RC rate: 1.3
RC expo: 0.75
Roll Pitch Yaw rate: 0.3

try different props, also balance motors (very important!).

anyone else? hello! common guys, I need help.

Im new to Multiwii, flying FPV and looking for other examples.

As of right now for version 2.0 my settings are:

RC rate: 1.2
RC expo: 0.65 (default)
Roll Pitch Yaw rate: 0.2

everything else by default

ok then, getting new chip.

I found place at "output" code, but need more information. //here i should replace 3 to A0 #if defined(PROMINI) uint8_t PWM_PIN[8] = {9,10,11,3,6,5,A2,12}; //for a quad+: rear,right,left,front #endif // and here i need to replace "COM2B1" to A0 definition, but don't know what... ...

Why don't you post your findings?


My D3 channel (motor 1) is dead, how to redirect to A1, A2, etc. ?

yes. I did. it's dead, fried. (I made mistake when short D3). however it will power the board (ESC).

I do believe it should be the way to use A0, A1...etc instead, by programming.

Please help to redirect from D3 pin to any A0,A1,A2..A7. D3- motor 1 in XQuad configuration. my D3 is dead.

please help.

Looks like I burnt D3 channel on my board, is it anyway to redefine this to A1-A7 pins in softwate. Please help!
Im using X-quad mode, 2.0 version.