Search found 4 matches
- Mon Oct 22, 2012 10:54 pm
- Forum: Software development
- Topic: Altitude Hold improvement solution
- Replies: 580
- Views: 1582026
Re: Altitude Hold improvement solution
naza is not the only project that uses ACC-Z to assist alt hold; Mikrokopter also makes use of the ACC and it worked very well. The source was published but I think its closed these days...
- Mon Oct 22, 2012 12:16 pm
- Forum: Software development
- Topic: Altitude Hold improvement solution
- Replies: 580
- Views: 1582026
Re: Altitude Hold improvement solution
hi guys, quite new to MW but not to multirotors. I setting up alt hold on MWC quad yesterday and found it worked terrible compared to my old miktokopter and I thought I read somewhere that MWC is not taking ACC-Z into consideration for alt-hold? is this true or has this been improved in MW 2.1 or ar...
- Sat Apr 28, 2012 10:23 pm
- Forum: Getting Started - MultiWii config and setup
- Topic: Motors 5 ad 6 not working
- Replies: 7
- Views: 2657
Re: Motors 5 ad 6 not working
am using version 2.0. I have swapped ESC connectors arround, always the ones connected to A0 and A1 don't run. Have connected to a KK board and all motors are spinning fine. Also, I think that I setup the code correct because it was working in the backyard. no changes but a couple of hours later, an...
- Fri Apr 27, 2012 9:56 pm
- Forum: Getting Started - MultiWii config and setup
- Topic: Motors 5 ad 6 not working
- Replies: 7
- Views: 2657
Motors 5 ad 6 not working
I currently have a weird problem i can't get my head arround. i just finished my hex build last night using a CRIUS SE board, everything seemed to work fine... today during lunch I started tuning the PIDs and quite quickly I had a realitve stable copter. but, here is what I don't understand... after...