MultiWii

@TC,

as you know about the code

Will it be possible to mod the buzzer out signal to have about 40kHz modulation on it - to abuse for IR transmitting purpose?
If not, what is preventing it from functioning - except not being coded yet?

Regards Peer

Guy's, not sure if I'm missed something, but I can't install TC's new HEX file from today. I get a message from the STM loader saying it can't use the file, and I've noticed the file size of the .HEX is 397Kb instead of around 150kb for previous versions. I used the same 'save file as' method as pr...

Hi JollyJoker ! With Crashpilot recommended settings it should be fine too on Harakiri 9 , are you sure that you set gps_ins_vel = 0 and gps_ins_pos = 1 your video look like you invert this parameters ? To set it, use Multiwiiconf and Putty for the moment it will be safer than some clone software !...

Looks damn good. Would you mind to share your settings?

Exactly the same video made today with 8+ sattelites in view. Only harakiri9 with recommended settings.
http://www.youtube.com/watch?v=KQKLCzhovmQ

Regards Peer

Hi Spagoziak,
did you know this project?
LCD-Config

Regards Peer

Thanks for this information Alex, i thought it would be easier. My idea behind was, just to treat the yaw-servo like an esc - for the generation of the pwm-pulse. So if this doesn´t work then i don´t want to make circumstances. I don´t had in mind that with this new release there are 4 servos to dea...

Hi Alex, is there a chance of getting a version of the code, which is driving the servo for the tri (three in my case) with full 49ß0 Hz output? Can you advise me how to change this. My full tilt copter does greatly improve yaw stability with every HZ i could gain. Now at 110Hz the end is reached wi...

I just finished some tests with different digital servos: MPX/Hitec, Hyperion, BMS/Turnigy, they all manage to work even on a ESC output of the arduino driven by 490Hz! Some are knurring a little, other are as quite all the same behavior as driven by 50Hz or 270Hz (HK401Gyro). So there should be no ...