dr.tom,
thanks for the links
i also wanted to know if there are other alternatives for the driver chips ... sourcing them here is bit too difficult ...
thanks in advance
CH
Search found 5 matches
- Thu Jan 31, 2013 9:24 pm
- Forum: Ideas
- Topic: Brushless direct drive GIMBAL - big revolution for a few $
- Replies: 84
- Views: 82447
- Thu Jan 31, 2013 3:23 am
- Forum: Ideas
- Topic: Brushless direct drive GIMBAL - big revolution for a few $
- Replies: 84
- Views: 82447
Re: Brushless direct drive GIMBAL - big revolution for a few
thanks dr. tom,
pls could you share the link on the german forum, where they have it unpopulated or populated (RTF) ??
thanks in advance
CH
pls could you share the link on the german forum, where they have it unpopulated or populated (RTF) ??
thanks in advance
CH
- Wed Jan 02, 2013 3:02 pm
- Forum: Getting Started - MultiWii config and setup
- Topic: MultiwiiCONF 2.1 ... help
- Replies: 2
- Views: 1321
Re: MultiwiiCONF 2.1 ... help
thanks scrat,
i redid the wiring and reloaded the sketch ... then all things worked fine
CH
i redid the wiring and reloaded the sketch ... then all things worked fine
CH
- Tue Jan 01, 2013 12:04 pm
- Forum: Getting Started - MultiWii config and setup
- Topic: MultiwiiCONF 2.1 ... help
- Replies: 2
- Views: 1321
MultiwiiCONF 2.1 ... help
hi, happy new year ... i have flyduino nano on my mini quad ... and have a big problem with Multiwiiconf 2.1 ... it recognizes the sensors but i just cant any inputs from the Tx on the screen to set ranges etc .. the setup is ... 1. 2700 kv motors with 3 blade 5 x 3 props 2. 20 amp esc flashed with ...
- Sun Dec 30, 2012 11:54 pm
- Forum: ESCs, propellers , servos and radios
- Topic: Tx problem? Tx values jumping up and down !?
- Replies: 7
- Views: 3347
Re: Tx problem? Tx values jumping up and down !?
hi patrike
how do you Make sure you have common ground on everyting in the setup.
i have a flyduino nano ... all setup
but i cant get the gui to show Tx inputs ...
thanks in advance
CH
how do you Make sure you have common ground on everyting in the setup.
i have a flyduino nano ... all setup
but i cant get the gui to show Tx inputs ...
thanks in advance
CH