MultiWii

No problems with them removed. It advances the timing slightly and helps starting on some motors. I just don't typically bother mentioning to remove them since it causes all of this these questions and confusion. By the way, the safety feature to prevent accidental starting...I just went with a ver...

Ah, great! Because it would be a lot of work to remove this three ones build in in my frame...

Thx!

I have some other Blue Series 40A here but on that i have removed the caps because the older quax firmware. Any known problems with the opposite, removed caps with simonk?

Hello! I have just finished my newest small Multiwii with Nanowii and Simonk flashed Blue Series 12A N-FET ESC and 8" props. All seems to be fine! It flys realllyyyy welll so far! Full throttle in my hand seems fine too. Outdoors i cant try because the bad weather. The question is now must i re...

Ah good to hear that you can confirm this behavior. Ok, not really good but... And not only the buzzer disturb the voltage, the reset of the WMP too! But the buzzer do that very strong (at least my loud thing...) I´m curious to read what your tests with VCC take! It should be better! The official vo...

PS: Yes, VCC is the 5V voltage after the onboard regulator on the Arduino, the self as D12 that is only a output here on the MWC Code. So the ATMega can switch the power supply on and of in order to reset the WMP.

I had the 5V BEC from the rear ESC used to power the Arduino Pro Mini over Pin RAW - and of course power the receiver. The WMP was connected without an diode directly to Pin D12. All normal as the scetch shows how to connect all together. The problem is that the Arduino has an onboard 5V regulator. ...

Hehe i don´t like it too But now all is ok and it was of course not a bug, only hardware configuration
Now i´m looking forward for my new MWCs and the brand new v1.7

FINALLY i found the problem! Big thanks to Jürgen aka X-Spieler from the german X-UFO Forum for his hints and help. The reason was that it is very bad to connect a 5V BEC from an ESC to the 5V regulator on the Arduino Pro Mini. Cause of that the regulator don´t regulate the voltage and then i have v...

I have nothing found yet. But this mainly i don´t know how to enclose the problem. If i can do something let me know! If i found something out i will post it.

The receiver can cause these problems or not? Because this receiver is the part that i plug on all of my MWCs because i have only one left. But how the receiver can cause the buzzer to beep? It is possible that massive I2C problems cause that problems? I hope i don´t ask stupid questions but i only ...

At first thx for the fast help I powered the Arduino over one ESC BEC from one ESC only on Pin RAW. Between, pullups, i must enable the "buildin i2c pullup" option in the source from the v1.6. Without that nothing happend and the programm don´t start up (visually, no beep, nothing, and no ...

Hello! I have actually a problem with all of my three MWCs. Today i have updated my middle MWC that never have a problem befor from 1.4 to 1.6 and - there it is! So from what i can say it only come up with higher than 1.4, maybe 1.6 only. v1.5 i never tested. The problem is: While flying my MWCs wil...